Deck permits and BMPs in Lake Tahoe, handled for you
Check your address to see who reviews your deck, how much coverage your lot allows, your BMP certificate status and your fire zone. Then we file it and build it.
Every BMP a Tahoe Basin property can be asked for
BMP means Best Management Practice: the stormwater controls TRPA requires inside the Tahoe Basin to keep sediment out of the lake. They apply in South Lake Tahoe, Meyers, Tahoe Keys, Tahoma, Homewood and the West Shore. They do not apply in Pollock Pines, Camino, Placerville or the rest of El Dorado County outside the basin.
Infiltration trench under the roof drip line
A gravel-filled trench where water drips off the roof edge. Roof runoff soaks into the ground instead of running across the lot. It goes along every roof edge without gutters and at downspout outlets, and is the most common BMP on a Tahoe home.
Do you need a permit for a deck?
Inside the Tahoe Basin (TRPA)
Yes, in almost every case. South Lake Tahoe, Meyers, Tahoe Keys, Tahoma, Homewood, Tahoe City and the rest of the basin sit under the Tahoe Regional Planning Agency. A deck adds land coverage, and TRPA reviews anything that adds coverage. The city or county issues the building permit, and in South Lake Tahoe, El Dorado County and Placer County they also review it for TRPA.
What decides the answer first: your parcel's land capability class and how much coverage already exists. That sets the ceiling on deck size before design starts.
El Dorado County outside the basin
Placerville, Pollock Pines, Camino, Shingle Springs, Cameron Park and El Dorado Hills. No TRPA. A building permit is required unless the deck meets all four: 200 sq ft or less, 30 inches or less above grade at any point, not attached to the house, and not serving a required exit door.
Attached decks always need a permit. In the higher foothill towns, expect snow-load engineering. We include the stamped calculations in our price.
How much deck your Tahoe lot is allowed
TRPA rates every parcel in the basin by how sensitive the ground is. The class sets the base percentage of the lot that can be covered by anything hard: house, driveway, deck, patio.
A slatted deck with open gaps and rock under it can qualify for TRPA's partial coverage exemption for pervious decks. Coverage can be bought from another parcel in the same watershed area and transferred to yours. Excess coverage mitigation runs about $8.50 to $25 per sq ft depending on the area. We price the cheapest path.
What a BMP Certificate is, and why your deck permit will ask about it
A BMP Certificate is TRPA's record that a property has its stormwater controls installed and inspected. Permits for new work usually require the BMPs be finished, or a security deposit posted until they are.
We check your BMP status before we quote. If the property needs a retrofit, we price the trenches, deck armor, driveway and revegetation into the deck job and schedule the TRPA inspection. One crew, one permit package, one certificate at the end.
How a Tahoe deck permit goes with Sierra Ridge
Parcel check: jurisdiction, land capability class, existing coverage and BMP certificate status from the public maps.
Design to the numbers: deck size, height and footings drawn to fit the allowed coverage.
Application package: site plan, coverage math, structural details, snow-load engineering where required, BMP plan.
TRPA and county review: we answer the comments. TRPA targets 120 days and averages about 90.
Build, BMPs, inspections: footings, framing, final, and BMP inspection if required. You get the closed permit and the certificate.
In a Very High fire zone, the deck material changes too
Most of the Highway 50 corridor and the basin sit in CAL FIRE High or Very High Fire Hazard Severity Zones. That means decking listed for California's wildfire code, closed-in or screened undersides, and ember-resistant details where the deck meets the house.
Deck permit and BMP questions we get every week
Do I need a permit to build a deck in South Lake Tahoe?
Almost always. Inside the Tahoe Basin a deck adds land coverage, so it gets TRPA review, and the City of South Lake Tahoe issues the building permit and reviews it for TRPA. How big the deck can be depends on your parcel's land capability class and existing coverage.
What is a BMP?
BMP stands for Best Management Practice. In the Tahoe Basin it means the stormwater controls TRPA requires on a property: infiltration trenches under roof drip lines, rock under decks, paved or stabilized driveways, rock-lined swales, slope stabilization and native revegetation. A BMP Certificate shows the property has them installed.
What is a BMP certificate in Lake Tahoe?
It is TRPA's record that a property's BMPs are installed and inspected. If your lot has no certificate, a new deck permit will usually require the BMP retrofit or a security deposit until it is done.
What is land coverage and why does it matter for my deck?
Land coverage is the part of your lot covered by buildings, decks, driveways and other hard surfaces. TRPA caps it by land capability class: 1% on classes 1a through 2, 5% on class 3, 20% on class 4, 25% on class 5 and 30% on classes 6 and 7. A deck counts toward that cap, though slatted pervious decks can qualify for a partial exemption.
Do I need a permit for a deck in El Dorado County outside Tahoe?
Only a deck that is 200 square feet or less, no more than 30 inches above grade at any point, not attached to the house and not serving a required exit door skips the permit. Any attached deck, or one bigger or higher than that, needs a building permit.
How long does a TRPA deck permit take?
TRPA aims to act within 120 days of a complete application and reports about 90 days on average. A complete package is the biggest thing you control.
What goes under a deck in Tahoe?
Deck armor: at least 3 inches of 3/4 to 1-1/2 inch clean drain rock under the deck, extending 12 inches past the deck edge, held in by a noncombustible border.
Can I build a deck on a Class 1 or Class 2 lot?
New coverage is generally not allowed on classes 1a through 2, and class 3 is very tight. There are narrow paths: relocating existing coverage, a coverage transfer, or a slatted deck under the pervious deck exemption.
Can Sierra Ridge pull the permit for me?
Yes. As a licensed California contractor (CSLB #1117955) we prepare and file the TRPA and city or county applications, install the required BMPs and build the deck.
Planning guide, not a permit determination. TRPA, El Dorado County, Placer County, the Town of Truckee and the City of South Lake Tahoe make the final call on every project. Last reviewed September 2026.
